Table of Contents
Advertisement
DISASSEMBLY
PRECAUTION
·
Never reuse non-reusable parts. (Failure to observe this caution may cause serious accidents.)
·
Prior to the disassembly, be sure to wipe off any sand or mud adhering to the outside of the power
steering gear assembly so that they may not get into the inside during the disassembly and assembly.
·
When disassembling and assembling, do not use gloves. These operations should be performed by
bare hands.
·
Be sure to always arrange the disassembled parts in order and protect them from dust, etc.
·
Prior to the assembling of each part, be sure to wash the part completely and dry it. Then, apply the
ATF DEXRON
II. As for aluminum and rubber sections, never wash them with alkaline chemicals. Also,
®
never wash rubber parts, such as O-rings and oil seals, with cleaning solvent (white gasoline, etc.).
·
Liberally apply the ATF DEXRON
·
When securing a part in a vice, be sure to interpose aluminum plates.
·
Be very careful not to scratch oil seals, O-rings and so forth during the installation.
·
Prior to the application of seal agents, be sure to wipe off thoroughly the old seal agent remaining at the
seal section. Then, wash the seal section with white gasoline and dry it.
·
When using compressed air, be sure to wear protective goggles.
1. Removal of turn pressure tube
Remove the turn pressure tubes from the rack housing as-
sembly, using the following SST.
SST:
09633-00020-000
CAUTION:
·
If the steering rack is moved with the turn pressure
tube removed, residual fluid may splash.
Therefore, care must be exercised so that no fluid may
get to your eyes.
NOTE:
·
Be very careful not to scratch the spool section during
the removal of the tube.
2. Remove the union seats from the cylinder tube side turn
pressure tube attaching hole.
3. Remove the bracket and grommet from the steering gear
housing.
4. Secure the power steering gear assembly with a vice,
using the following SST.
SST:
09612-00012-000
NOTE:
·
When the SST is installed to the power steering gear
assembly, a gap will be formed. At this time, be very
careful not to damage the rack housing by excessively
tightening the attaching nuts of the SST.
·
Be sure to evenly tighten the attaching nuts of the SST.
II to sliding surfaces and rotating sections before assembling them.
®
SR–19
JSR00061-00000
JSR00062-00055
JSR00000-00056
JSR00063-00057
Advertisement
Table of Contents
