Table of Contents
Advertisement
TR–6
4. Remove the speedometer shaft sleeve by removing the
bolt.
5. Remove the drain plug.
6. Remove the filler plug.
7. Remove the transfer case by removing the attaching bolts.
NOTE:
•
While lightly tapping the transfer case at the rib sec-
tions, using a plastic hammer or the like, remove the
transfer case.
8. Remove the transfer output front shaft with the radial ball
bearings.
9. Detach the snap ring of the speedometer drive gear.
10. Remove the speedometer drive gear.
11. Remove the lock nut of the radial ball bearing in the trans-
fer output rear shaft.
NOTE:
•
Release the staking of the lock nut, using a suitable
chisel and a hammer.
•
Prior to loosen the nut, grab the shaft by the vise with
the soft metal for not rotating.
(Be careful not to damage the shaft.)
•
Never reuse the removed nut.
Filler plug
Rib
Drain
section
plug
JTR00018-00403
Rib section
JTR00019-00404
JTR00020-00405
JTR00021-00406
JTR00022-00407
Advertisement
Table of Contents
