Daihatsu 1997 Terios J100 Service Manual page 378

MT–32
5. Measure the thickness of the 1st gear thrust washer.
Specified Value:
6. Measure the dimensions between the outer diameter of
the synchronizer No. 1 hub (A) and the bore diameter of
synchronizer hub sleeve (B).
[Reference information]
The parts (A) and (B) are available only as a set. An identi-
fication mark is applied to the end surface of the synchro-
nizer hub.
Classifica-
(A)
tion
No. 2 69.78 - 69.84
No. 1 69.68 - 69.74
No. 3 69.58 - 69.64
CAUTION:
·
When replacing those parts (A) and (B), be sure to re-
place them as a set.
7. Measure the thickness (A) of the synchronizer No. 1 hub.
Specified Value:
8. Measure the inner diameter of 1st and 2nd gear.
Specified Value
9. Measure the thickness of 1st and 2nd gear.
Specified Value
4 ± 0.03 mm
(B)
69.871 - 69.97
69.771 - 69.87
69.67 - 69.77
27 ± 0.03 mm
1st gear (A) 2nd gear (B)
+0.025
37.0
+0
1st gear (C) 2nd gear (D)
27.34 ± 0.03 36.30 ± 0.03
Unit: mm
Identifica-
tion
Yellow
None
White
Unit: mm
Unit: mm
JMT00086-00071
JMT00087-00072
JMT00088-00073
1st gear 2nd gear
JMT00089-00074