Daihatsu 1997 Terios J100 Service Manual page 566

ASSEMBLY
1. Install the washer and bush to the stabilizer link rod.
2. Install the stabilizer link rod to the stabilizer bar.
3. Install the bush and washer to the stabilizer link rod. Then,
tighten the stabilizer bar end upper nut.
CAUTION:
·
Be sure to assemble the bush and washer as shown in
the right figure.
INSTALLATION
1. Install the stabilizer link rod, washer and bush to the sus-
pension lower arm with the attaching nuts as shown in the
right figure. Then, tighten the stabilizer bar end lower nut
temporary.
CAUTION:
·
Be sure to insert the protrusion section on the washer
B to the hole provided on the stabilizer bracket on the
suspension lower arm.
2. Attach the bushes to the stabilizer bar.
CAUTION:
·
Be sure to attach the bushes to the stabilizer bar in
such manner that the bushes should be attached on
the mark provided on the stabilizer bar during installa-
tion.
3. Install the stabilizer bar to the stabilizer bracket sub-as-
sembly by installing the stabilizer bracket with the attach-
ing bolts. Then, tighten the attaching bolts to specified
tightening torque.
Tightening Torque:
4. Tighten the stabilizer bar end lower nut.
Tightening Torque:
5. Jack down the vehicle.
12.7 - 23.5 N·m (1.3 - 2.4 kgf-m)
12.7 - 23.5 N·m (1.3 - 2.4 kgf-m)
FS–13
Nut
Washer
Bush
Washer
Washer A
Bush
Washer A
Bush
Washer B
Bush
Washer A
Marker
JFS00042-00042
JFS00043-00043
JFS00044-00044
JFS00045-00045