Daihatsu 1997 Terios J100 Service Manual page 559

FS–6
(3) Pull out the front axle hub sub-assembly with inner
bearing race, using the following SST.
SST: 09520-00031-000
CAUTION:
·
Never reuse the removed bearing.
9. Remove the sensor mounting bracket with the skid control
sensor from the steering knuckle by removing the attach-
ing bolts.
(Only for vehicles equipped with ABS.)
10. Removal of steering knuckle
(1) Disconnection of tie-rod end from steering knuckle
q Remove the clip.
w Loosen the castle nut until the upper end of the
castle nut becomes flash with the end of the
threaded section of the lower ball joint.
e Disconnect the tie-rod end from the steering
knuckle, using the following SST.
SST: 09611-87701-000
r Disconnect the tie-rod end from the steering
knuckle by removing the castle nut.
CAUTION:
·
Never make damage on the threaded section of ball
joint during the disconnection using the SST.
(2) Disconnection of suspension lower arm from steering
knuckle
q Remove the clip.
w Loosen the castle nut until the upper end of the
castle nut becomes flash with the end of the
threaded section of the lower ball joint.
e Disconnect the suspension lower arm from the
steering knuckle, using the following SST.
SST: 09611-87701-000
r Disconnect the suspension lower arm from the
steering knuckle by removing the castle nut.
CAUTION:
·
Never make damage on the threaded section of ball
joint during the disconnection using the SST.
SST
JFS00014-00014
JFS00015-00015
JFS00016-00016
JFS00017-00017