Table of Contents
Advertisement
18. Connect the connector to the water temperature sensor.
19. Install the ignition coil to the cylinder head cover and tight-
en it.
Tightening Torque:
20. Connect the resistive cords between the ignition coil and
the spark plug.
IG coil for No. 2 cylinder – No. 3 cylinder
IG coil for No. 4 cylinder – No. 1 cylinder
21. Installation of exhaust manifold
(1) Install the new exhaust manifold gasket in such a way
that the arrow mark can be visible and it faces toward
the timing belt.
(2) Install the exhaust manifold to the cylinder head.
NOTE:
•
Be very careful not to interfere with other parts.
(3) Install and tighten the attaching bolts and nuts evenly
over two to three stages, following the sequence in the
right figure.
Tightening Torque:
(4) Install a new O-ring to the oil level gauge guide.
CAUTION:
•
Do not reuse the O-ring.
(5) Insert the oil level gauge guide to the cylinder block.
CAUTION:
•
Be very careful not to damage the O-ring.
(6) Install the exhaust manifold heat insulator to the ex-
haust manifold with the attaching bolts and nut.
2.9 - 4.9 N·m
29.4 - 44.1 N·m
Allow mark
u
w q
e
y
EM–55
JEM00223-00207
JEM00224-00208
t
r
i
JEM00225-00209
JEM00226-00000
JEM00227-00210
Advertisement
Table of Contents
