Table of Contents
Advertisement
15. Visually inspect the differential case sub-assembly for
damage or wear.
16. Measure the outer diameter of the differential pinion shaft.
17. Measure the inner diameter of the differential pinion.
Inner
Pinion
diameter
Outer
Pinion
diameter
Shaft
18. Measure the inner diameter of the transfer front and rear
output shaft bearing.
NOTE:
•
If the measured value does not conform to the specifi-
cation, replace the transfer case.
Output front shaft
bearing
Output rear shaft
bearing
19. Visually inspect the type T oil seal in the diaphragm cylin-
der for damage or wear.
NOTE:
•
Replace the oil seal if it exhibits damage or wear.
20. Visually inspect the type K oil seal of the front drive shift
link lever for damage or wear.
NOTE:
•
Replace the oil seal if it exhibits damage or wear.
Specified value
Allowable limit
+0.06
15
+0.03
–0.016
15
14.943
–0.043
Inner diameter specified value
–.0
Front
25
–0.010
–.0
Rear
17
–0.008
–.0
Front
50
–0.012
–.0
Rear
25
–0.010
Unit: mm
15.06
Unit: mm
TR–13
JTR00053-00615
JTR00054-00617
JTR00055-00618
JTR00056-00619
JTR00057-00620
Advertisement
Table of Contents
