Table of Contents
Advertisement
MT–8
3. OPERATION AFTER REMOVAL
(1) Ensure that the locating pin is positioned securely at both the transmission and engine sides.
NOTE:
·
Make sure to replace the locating pin that has exhibited severely scored.
Locating pin
(at transmission side)
Transmission side
Engine side
4. MAIN POINTS OF INSTALLATION
(1) With the transmission assembly with transfer support-
ed by a transmission jack, etc., bring the surface of
the transmission in close contact with the surface of
the engine. Tighten the attaching bolts to the specified
torque.
Tightening Torque:
(2) Tighten the attaching bolts of the stiffener left plate.
Tightening Torque:
(3) Tighten the attaching bolts of the stiffener right plate.
NOTE:
·
Temporarily tighten the -marked bolts until the stiffen-
er plate is brought in close contact with the transmis-
sion. Securely tighten the
Then, proceed to tighten the
specified torque.
Tightening Torque:
(4) Install the power train stiffener in the direction as indi-
cated in the right figure.
NOTE:
·
Temporarily tighten the
en the
-marked bolts. Then, proceed to tighten the re-
maining two bolts securely.
Tightening Torque:
49.0 - 68.6 N·m (5.0 - 7.0 kgf-m)
29.4 - 44.1 N·m (3.0 - 4.5 kgf-m)
-marked bolts.
-marked bolts to the
29.4 - 44.1 N·m (3.0 - 4.5 kgf-m)
-marked bolts. Securely tight-
29.4 - 44.1 N·m (3.0 - 4.5 kgf-m)
Locating pin (at engine side)
Engine side
Transmission side
Stiffener left plate
Identification mark
JMT00012-00009
JMT00013-00010
Stiffener right plate
JMT00014-00011
JMT00015-00012
Advertisement
Table of Contents
