Table of Contents
Advertisement
CL–10
(3) Apply EP grease to the entire periphery of the sliding
surface of the release fork support.
(4) Apply EP grease to the entire inner periphery of the
clutch release bearing hub assembly. Install the clutch
release fork to the transmission.
(5) Thinly apply EP grease to the spline section of the
clutch disc assembly.
NOTE:
•
The grease should be applied from the clutch cover
side. Be sure to apply the grease as sparsely as possi-
ble so that no excess grease may ooze out to the fly-
wheel side.
Specified Amount:
(6) With the clutch disc assembly placed at the center po-
sition by means of the following SST, install the clutch
disc assembly to the flywheel.
SST:
09301-87703-000
NOTE:
•
Be very careful not to mistake the installation direction
of the clutch disc assembly.
(7) Install the clutch cover assembly, aligning with the lo-
cating pins of the flywheel at three points. Tighten the
six bolts to the specified torque, while preventing the
flywheel from turning by means of the following SST.
SST:
09210-87701-000
NOTE:
•
As for the tightening sequence of the bolts, first tem-
porarily tighten the bolt (1). Then, fully tighten the bolts
in order of (2) - (3) - (1) - (4) - (5) - (6). (Here, any bolt
can be the bolt (1).)
Tightening Torque:
0.1 - 0.2 g
14.7 - 21.6 N·m (1.5 - 2.2 kgf-m)
Apply grease
Apply grease
Apply grease
SST
1
6
3
5
JCL00023-00021
JCL00024-00022
JCL00025-00023
JCL00026-00024
4
2
JCL00027-00025
Advertisement
Table of Contents
