Table of Contents
Advertisement
26. Remove the register assembly No. 2 of the instrument
panel by unlocking the lock section on the instrument
panel assembly.
CAUTION:
·
Do not enlarge the attaching portion of the instrument
panel more than necessary to remove the register.
27. Remove the defroster nozzle assembly and side defroster
duct subassembly (right and left) from the cowl panel and
bracket by removing the attaching screws and bolt.
28. Removal of instrument panel reinforcement assembly
(Only when equipped)
(1) Disconnect the relay box from the bracket by removing
attaching bolt, while unlocking the lock of the relay
box.
Disconnect the wire clamps and antenna cable from
the reinforcement.
(2) Remove the instrument panel reinforcement assembly
by removing the attaching bolts and nut.
INSTALLATION
NOTE:
·
Basically the installation procedure is reverse to the removal procedure. Therefore, illustrations are
not given in this installation procedure. Refer to the illustration in the removal procedure in cases
where any difficulty is encountered.
1. Installation of instrument panel reinforcement assembly (Only when equipped)
(1) Install the instrument panel reinforcement assembly with the attaching bolts and nuts.
(2) Install the relay box to its bracket.
2. Install the defroster nozzle assembly and side defroster duct subassembly with the attaching screws
(right and left) to the cowl panel and bracket.
3. Install the register assembly No. 2 of the instrument panel to the instrument panel subassembly.
CAUTION:
·
Do not enlarge the instrument panel more than necessary.
4. Install the instrument panel center register assembly to the instrument panel subassembly with the at-
taching screws .
5. Installation of front passenger seat side airbag
WARNING:
·
Be sure to refer to the handling instruction mentioned in the BE section before performing the instal-
lation of the front passenger seat side airbag. Failure to observe this warning may lead to serious
trouble or malfunction.
(1) Install the front passenger seat side airbag assembly to the instrument panel and ensure that the
locks on the front passenger seat side airbag assembly are locked to the instrument panel properly.
(2) Install the two attaching nuts of the front passenger seat side airbag and tighten them securely.
6. Install the heater-to-register center duct subassembly with the attaching screws.
7. Install the front ash receptacle retainer with the attaching screws.
8. Install the instrument panel subassembly with the attaching bolts.
CAUTION:
·
Be sure to tighten the attaching bolts of passenger side airbag to the specified tightening torque, if
model equipped with passenger side airbag.
Tightening Torque:
6.7 ± 1.6 N·m (0.7 ± 0.2 kgf-m)
Bolt
BO–35
JBO00091-00080
JBO00092-00081
Advertisement
Table of Contents
