Table of Contents
Advertisement
ASSEMBLY
NOTE:
•
Prior to the assembly, clean the transfer case and the
parts by removing any dirt or the like. And then, apply
gear oil to the all parts.
1. Press the radial ball bearing (Front) to the transfer output
front shaft.
2. Press the radial ball bearing (Rear) to the transfer output
front shaft, using the following SST.
SST:
09238-87202-000
3. Press the radial ball bearing to the transfer inner hub,
using the following SST.
SST:
09388-20010-000
NOTE:
•
Make sure that the groove section of the redial ball
bearing comes upper side.
4. Install the differential side gear to the differential case.
5. Install the differential pinion shafts, the differential pinions
and the differential pinion thrust washers to the differential
case No. 2.
NOTE:
•
Make sure that the machine-ground side of the differ-
ential pinion shaft section faces toward differential side
gear.
6. Align the pinion shafts and shaft holes. Then, Insert the
differential case sub-assembly to the differential case
No. 2.
TR–15
SST
SST
Groove
section
Machine
ground side
Differential
case No. 2
JTR00061-00701
JTR00062-00702
JTR00063-00703
Differential
case
JTR00064-00705
JTR00065-00706
Advertisement
Table of Contents
