Table of Contents
Advertisement
GI–6
ABBREVIATION CODES
The abbreviation codes that appear in this workshop manual stand for the following, respectively.
Abbreviation code
Original word
A/C
Air Conditioner
Automatic Transmission Refers to automatic transmission
A/T, AT
A/Y or Ay
Assembly
API
American Petroleum
Institute
ECU
Electronic Control Unit Refers to electronic control unit.
Electronic
EFI
Fuel Injection
F/L
Fusible Link
L.H.D.
Left-Hand Drive
LH
Left Hand
M/T, MT
Manual Transmission
MP
Multipurpose
O/S
Oversize
PR
Ply Rating
R.H.D.
Right-Hand Drive
RH
Right Hand
S/A
Sub-Assembly
SAE
Society of Automotive
Engineers
SST
Special Service Tool
STD
Standard
T
Torque
U/S
Under Size
VSV
Vacuum Switching
Valve
W/
With
ETR
Electronic Tuning
Radio
The abbreviation codes that appear in the figure stand for the following, respectively.
B
Bolt
N
Nut
Refers to air conditioner.
Refers to an assembled component comprising more than two single parts or sub-assembly
parts.
The standards set forth by the American Petroleum Institute (abbreviated as API
Classification) have been employed to evaluate and classify properties of various oils.
Engine oils for gasoline engines are classified as SD, SE, SF and so on, whereas engine oils
for diesel engines are classified as CC, CD and so on.
Refers to electronic fuel injection.
Refers to fusible link.
Left-hand drive vehicle.
Refers to left side.
Refers to manual transmission.
Means that the following item has multi-purposes.
In instances where fitting becomes too loose due to wear resulting from use for a long period
of time or due to frequent removal/installation operations, if the fitting part (e.g. piston) is
replaced with a part having larger dimensions, the other mating part may be put into use
again. "Oversized" parts denote those parts having larger dimensions compared with the
standard parts.
Represents strength of tires.
The larger the ply rating number, the stronger the tire strength.
Right hand drive vehicle
Refers to right side.
Refers to a component comprising more than two single parts which are welded, staked, or
studded to each other to form a single component.
For example, automotive oils are designated as SAE so and so number.
These designation numbers have been set forth by the Society of Automotive Engineers in the
United States of America (SAE). The larger the SAE number, the higher the oil viscosity.
Conversely, the smaller the SAE number, the lower the oil viscosity.
Refers to a tool designed for a specific purpose.
When referring to automotive parts, "standard" represents those parts which have been
installed originally by the manufacturer and which have standard dimensions.
Refers to tightening torque.
In the same manner as with the "oversized" parts, if fitting part (e.g. bush and bearing) is
replaced with a part having smaller bore dimensions, the other mating part may be put into
use again. "Under sized" parts denote those parts having smaller dimensions compared with
standard parts.
Refers to vacuum switching valve.
Denotes that the following part is attached.
Radio which incorporates variable capacitance, etc. which varies the value according to an
applied voltage or current.
S
Screw
W
Washer
Meaning
JGI00006-00000
JGI00007-00000
Advertisement
Table of Contents
