Table of Contents
Advertisement
CO–18
(5) Connect the radiator hose No. 1 and the breather
hoses to the radiator upper tank.
(6) Connect the radiator hose No. 2 to the radiator lower
tank.
(7) Connection of oil cooler hoses (A/T vehicle for
European market only)
q Remove the oil cooler hoses.
w Wipe off any oil from the connecting section of the
oil cooler hoses.
e Connect new oil cooler hoses. Install new hose
clips.
CAUTION:
•
Never reuse the oil cooler hoses and hose clips.
•
Make sure that no oil or dirt gets to the connected sec-
tions.
•
Failure to observe this caution will cause the hoses to
be disconnected.
(8) Add automatic transmission oil
(See the Chassis Workshop Manual)
(9) Install the power steering vane pump.
2. Fill the coolant.
(See page CO–9.)
3. Connect the battery ground cable to the negative (–) ter-
minal of the battery.
4. Start the engine and check it for leakage.
Repair the leaky point if leakage exists.
JCO00062-00052
JCO00063-00053
JCO00064-00054
JCO00065-00055
Advertisement
Table of Contents
