Table of Contents
Advertisement
MA–12
t Cleaning of charcoal canister
Clean the charcoal canister by blowing com-
pressed air of 294.2kPa (3.0 kg/cm
tank side pipe B while holding the purge side of
the canister pipes A closed.
CAUTION:
·
Never attempt to wash the charcoal canister.
No activated carbon should come out during the test.
If activated carbon comes out, replace the charcoal
canister.
(3) Installation of charcoal canister
The installation procedure is basically reverse to the
removed procedure. Therefore, no illustration is given
in this installation procedure.
q Install the charcoal canister to the charcoal canis-
ter holder and lock it securely.
w Connect the atmosphere side hose to the charcoal
canister.
e Install the engine undercover with the six attaching
bolts and tighten them securely.
r Connect the rubber hoses and attach new hose
bands.
CAUTION:
·
Never reuse the removed hose band.
7. Replacement of evaporative emission control hose
Replace the fuel evaporative emission control hoses with
new ones when the replacement interval arrives.
WARNING :
·
Replace the hose bands and clips with new ones.
Never reuse the removed hose bands and clips.
2
) into the fuel
JMA00023-00000
JMA00024-00018
JMA00025-00019
JMA00026-00020
JMA00027-00021
Advertisement
Table of Contents
