Daihatsu 1997 Terios J100 Service Manual page 485

AT–84
(3) Install the valve body assembly with the aforesaid SST
to the transmission case.
NOTE:
•
Ensure that the protrusion of the manual valve lever (A)
and grooved section of the manual valve (B) are
matched securely.
(4) Tighten the bolts of the valve body assembly.
Tightening Torque:
NOTE:
•
The numeral in the right illustration indicates the nomi-
nal length of the bolt.
•
If the bolt is tightened with any oil getting to the bolt's
threaded portion, it may cause the bolt looseness.
Therefore, be sure to clean the bolt threaded portion by
applying compressed air.
•
Care must be exercised so that the wire may not be
caught in between the transmission case and the valve
body assembly.
(5) Connect the connector of the solenoid wire assembly.
35. Tighten the (A) bolt firstly with the aforesaid SST. Then,
proceed to tighten the (B) bolt of the manual detent
spring.
Tightening Torque:
NOTE:
•
The numeral in the right figure indicates the nominal
length of the bolt.
(A) = 12 mm
•
Be sure to tighten the bolts alternately.
36. Assembly of oil strainer
(1) Coat a new O-ring (A) with ATF.
(2) Install the new O-ring to the groove section of the valve
body.
6.9 - 9.8 N·m (0.7 - 1.0 kgf-m)
6.9 - 9.8 N·m (0.7 - 1.0 kgf-m)
(B) = 40 mm
(B)
(A)
$0
$0
$0
@0
(A)
(B)
JAT00250-00224
@0
@0
@0
@0
JAT00251-00225
JAT00252-00226
JAT00253-00227
O-ring
JAT00254-00228