Table of Contents
Advertisement
9. Remove the lock nut for the rack guide spring cap, using
the following SST.
SST:
09922-10010-000
(Width across flats: 42 mm)
10. Remove the rack guide spring cap, using the following
SST.
SST:
09612-10020-000
(Width across flats: 24 mm)
11. Remove the rack guide spring, rack guide and rack guide
seat.
12. Put a mating mark on the control valve housing and rack
housing.
13. Remove the control valve housing by removing attaching
bolts.
14. Remove the O-ring from the valve housing.
15. Removal of control valve
(1) Put the control valve housing in a vice.
(2) Affix a tape or the like to the pinion section of the steer-
ing gear so as to prevent the pinion section from being
damaged.
(3) Remove the bearing guide nut, using the following
SST.
SST:
09631-20060-000
(4) Remove the O-ring from the bearing guide nut.
16. Remove the dust cover.
17. Remove the control valve by tapping it, using a plastic
hammer or the like.
18. Remove the cylinder end stopper, using the following SST.
SST:
09631-20090-000
24 mm
SST
SR–21
42 mm
JSR00068-00062
JSR00069-00063
JSR00070-00064
JSR00071-00065
JSR00072-00066
Advertisement
Table of Contents
