Daihatsu 1997 Terios J100 Service Manual page 631

BR–28
14. Install the compression spring and wheel cylinder pistons
with the wheel cylinder boots to the wheel cylinder.
NOTE:
·
Loosen the bleeder plug fully before installing the
wheel pistons.
15. Apply brake grease to the six brake shoe contacting
points on the backing plate, one point each on the wheel
cylinder pistons and two points on the brake lining anchor.
WARNING:
·
Be careful not to allow lubricants, such as grease or oil
etc., to get to the wheel cylinder boot or brake shoe lin-
ing.
16. Connect the parking brake cable to the parking brake
shoe lever.
17. Install the rear side brake shoes on the backing plate with the shoe hold-down pin, spring and retainer.
18. Connect the tension spring to the back side of the brake shoe.
19. Connect the other side of the brake shoe to the tension spring.
20. Thinly apply brake grease to the sliding section of the parking brake shoe strut.
21. Install the other side of the brake shoe to the backing plate with the shoe hold-down pin, spring and re-
tainer while placing the parking brake shoe strut in position.
22. Install the tension No. 4 spring to the brake shoes, using the following SST.
SST: 09921-00010-000
23. Clean the brake drum contacting surface of the rear axle hub and axle hub contacting surface of the
brake drum properly.
24. Install the brake drum to the rear axle hub.
CAUTION:
·
Never allow the brake drum to interfere with the brake shoe during the installation.
·
Make sure that the parking brake lever strut is retracted fully before the installation.
25. Install the rear wheels.
Tighten the attaching hub nuts to the specified tightening torque.
Tightening Torque:
26. Perform air bleeding. (Refer to the "Air bleeding" section.)
27. Apply the parking lever several times, until the clicking sounds emitted from the rear brake will stops.
103.0 ± 14.7 N·m (10.5 ± 1.5 kgf-m.)
JBR00092-00078
JBR00093-00079
JBR00094-00000
JBR00095-00000