Table of Contents
Advertisement
BR–70
UNIT INSPECTION & REPLACEMENT
NOTE:
·
The inspection of each sensor circuit should be performed by reoffering to the ABS RELATED CON-
NECTORS and ABS CIRCUIT CONNECTION TABLE.
·
Utilize the following SST effectively by reoffering to the unit inspection of the ABS ECU.
SST:
09842-87401-000
·
Never connect the connector of the SST to the ABS ECU during the inspection of continuity. Failure
to observe this note may lead to wrong diagnosis results.
SOLENOID RELAY
1. Turn off the ignition switch.
2. Remove the solenoid relay from the dash panel by removing the attaching bolt.
3. Disconnect the connector of the wire harness connected to the solenoid relay.
NOTE:
·
The solenoid relay is installed on the dash panel around the front center side of the front right seat.
4. Ensure that continuity exists between the terminals BS and
GND of the solenoid relay.
If no continuity exists, replace the solenoid relay with a
new one.
5. Ensure that the resistance between the terminals R+ and
SR within the specified value.
Specified resistance:
If the measured resistance fails to meet the specified
value, replace the solenoid relay with a new one.
6. Ensure that continuity exists between the terminals +BS
and BS when the battery voltage is applied across the
terminals R+ and SR.
If no continuity exists, replace the solenoid relay with a
new one.
7. Install the solenoid relay to the dash panel with the attach-
ing bolt.
8. Connect the connector of the wire harness to the solenoid
relay.
80 W (at 20 °C)
NOTE: LHD model
BS
+BS
w
q
t
r
e
SR
GND
R+
JABS00071-00000
JABS00072-00000
JABS00073-00034
4
NC
2
NO
1
3
5
JABS00074-00035
Advertisement
Table of Contents
