Daihatsu 1997 Terios J100 Service Manual page 686

y Remove the jump wire in the SST terminals.
NOTE:
•
Proceed to check the remaining right and rear wheels as mentioned in step (3).
u Disconnect the negative terminal of the ground cable from the negative terminal of the battery.
i Remove the SST from the connector of the wire harness.
o Connect the connector of the wire harness to the ABS ECU.
10. Connect the negative terminal of the ground cable to the negative terminal of the battery.
(3) Inspection of right side front wheel and rear wheels
CAUTION:
•
The terminals of the SST shown in this step are to be connected for each inspection.
•
However, the step-by-step procedure is not given in this step. The inspection procedure of the right
side front wheel and rear wheels is the same as the left side front wheel, except terminals to be con-
nected in the SST. Therefore, follow the procedure mentioned in "Inspection of left side front wheel",
except terminals in the SST to be connected.
q Right side front wheel
•
Connect the terminals No. 8 and 29 to terminal 19.
•
Connect the terminals No. 4 and 5 to terminal No.
40.
•
Connect the terminals No. 3 and 18.
w Rear wheels
•
Connect the terminals No. 22 and 23 to terminal
19.
•
Connect the terminals No. 4 and 5 to terminal No.
40.
•
Connect the terminals No. 3 and 18.
4. Function check of actuator using DS-21
(1) Preparation before inspection
q Check the brake system, using a brake tester.
w Jack up the vehicle and support it with safety
stands.
(Refer to GI section for supporting position of the
safety stand.)
e Release the parking brake.
r Place the shift lever to the neutral position.
t Ensure that the wheels turn properly.
BR–83
LABS00112-00000
LABS00113-00000
e r t i
@9
!8 !9
$0
LABS00114-00060
e r t
@2 @3
!8 !9
$0
LABS00115-00061
LABS00116-00000