Daihatsu 1997 Terios J100 Service Manual page 449

AT–48
REMOVAL
1. Remove the bolt of the transmission oil filler tube sub-
assembly.
2. Pull out the transmission oil filler tube subassembly toward
upside.
3. Remove the O-ring from the transmission oil filler tube
subassembly.
NOTE:
•
Never reuse the removed O-ring.
4. Remove the breather plug (A) and union bolts (B) (for oil
cooler).
NOTE:
•
Never reuse the removed gaskets.
5. Remove the clamp (C) for the throttle cable.
6. Removal of governor valve
(1) Remove the hole snap ring, using standard snap ring
pliers.
(2) Remove the governor cover with the O-ring installed,
using standard pliers.
(3) Remove the O-ring from the governor cover.
NOTE:
•
Never reuse the removed O-ring.
(4) Remove the governor body assembly from the trans-
mission case.
(5) Remove the ball (A), using a standard magnet hand.
7. Detach the connector (A) of the solenoid wire assembly
from the clamp of the control cable bracket.
8. Removal of neutral start switch assembly
(1) Remove the control cable bracket by removing the two
bolts.
(2) Detach the connector (B) (of the neutral start switch)
from the clamp of the control cable bracket.
(B)
(A)
(B)
(A)
(B)
(A)
JAT00092-00071
(C)
JAT00093-00072
JAT00094-00073
JAT00095-00074
JAT00096-00075