Table of Contents
Advertisement
RS–16
4. Installation of rear axle shaft bearing inner retainer.
(1) Heat the retainer to 150 ± 15°C in an oil bath.
NOTE:
•
Perform this operation promptly before the retainer
temperature drops.
•
When the temperature exceeds 150 ± 15°C, the sur-
face of the retainer will be turned to yellow. In this case,
be careful not to heat the retainer any further.
WARNING:
•
Special attention must be paid not to burn yourself.
(2) Install a new retainer to the rear axle shaft, using a hy-
draulic press.
Replacement of rear axle shaft housing oil seal
1. Remove the rear axle shaft housing oil seal, using the fol-
lowing SST.
SST :
09308-00010-000
2. Install a new oil seal to the rear axle shaft housing, using
the following SST.
SST :
09517-12010-000
CAUTION:
•
Make sure that the oil seal assumes the position indi-
cated in the figure.
3. Apply lithium-based multi purpose grease to the lip sec-
tion of the installed oil seal.
Inner retainer
150ϒC
4.8±0.5
Oil bath
JRS00049-00046
JRS00050-00000
JRS00051-00048
JRS00052-00049
Advertisement
Table of Contents
