Table of Contents
Advertisement
20. Install the crankshaft timing belt pulley attaching bolt.
Tighten the bolt to the specified torque.
Tightening Torque:
NOTE:
•
Prevent the crankshaft from turning, using the following
SST.
SST:
09210-87701-000
21. Install the air conditioner compressor bracket.
Tightening Torque:
22. Installation of oil filter
(1) Thinly apply engine oil to the oil seal of the oil filter.
(2) Screw in the oil filter until the oil seal of the oil filter
comes in contact with the oil pump or the contact sur-
face of the oil cooler.
(3) Then, rotate the oil filter further one complete turn (360
degrees), using the following SST.
SST:
09228-87201-000
88.3 - 98.0 N·m
29.4 - 44.1 N·m
EM–111
JEM00473-00426
JEM00474-00427
JEM00475-00428
Oil seal
JEM00476-00429
JEM00477-00430
Advertisement
Table of Contents
