Table of Contents
Advertisement
22. Disconnect the brake pipe from the wheel cylinder by dis-
connecting the flare nut, using a flare nut wrench.
23. Remove the wheel cylinder by removing the attaching
bolts.
24. Disconnect the parking brake cable from the backing
plate by removing the two attaching bolts.
25. Remove the wheel speed sensor by removing the attach-
ing bolt. (Only when equipped)
26. Remove the backing plate.
(Refer to the RS section.)
INSPECTION
1. Inspect the components with point mentioned in figure.
If any damage is found, replace the damaged parts with new ones.
Backing plate
Wear / rust / warpage / damage
Shoe hold-down
spring pin
Wear / rust
Wheel cylinder
Rusting / wear / cracks
Parking brake lever pin
Rusting / wear / damage
Spring
wear / rust /
stretching
Parking brake shoe strut
Wear / damage
BR–25
JBR00082-00069
JBR00083-00070
Brake shoe
Wear :
Brake lining thickness
Specified thickness: 5.0 mm
Allowable limit: 1.0 mm
Rusting / crack / burning
adhesion of oil
Spring
Wear / rusting / stretching
Brake drum
Wear / rusting / cracks / damage
JBR00084-00071
Advertisement
Table of Contents
