Rear Brake - Daihatsu 1997 Terios J100 Service Manual

Table of Contents

Advertisement

MA–32

REAR BRAKE

COMPONENTS
9.8 ± 2 (1.0 ± 0.2)
B
!5
e
o
INSPECTION OF BRAKE LINING THICKNESS
1.
Jack up the vehicle and support it with safety stands.
(Refer to the GI section.)
2.
Remove the hole plug provided on the backing plate as
shown in the figure.
3.
Inspect that the thickness of the brake shoe lining is more
than the specified value through the inspection hole.
Thickness of Brake Lining
Standard Thickness:
Minimum Thickness:
Replace the brake shoe, if the lining thickness is less than
the specified value.
If the brake lining is less than the specified value, check
the brake drum inner diameter.
(Refer to the BR section.)
4. Install the hole plug securely.
CAUTION:
·
Be sure to install the hole plug securely. Failure to ob-
serve this caution may lead to rear brake problems
owing to admission of dust, mud, water, etc.
!3
!8
!2
!1 1
61 ± 7 (6.25 ± 0.75)
r
!0
t
w
q
5 mm
1 mm
!6
!7
!5
!4
!4
!5 !7
o
i
u
y
q Brake drum subassembly
w Brake shoe hold down spring
e Shoe hold down spring pin
r Tension No. 4 spring
t Tension No. 3 spring
y Tension spring
u Automatic adjust lever (R, L)
i Parking brake shoe lever subassembly (R, L)
o Brake shoe assembly
!0 Parking brake shoe strut
!1 Rear wheel brake cylinder assembly
!2 Bleeder plug
!3 Brake backing plate subassembly
!4 Wheel cylinder boot
!5 Wheel brake cylinder piston
!6 Compression spring
!7 Cylinder cup
!8 Bleeder plug cap
: Tightening torque
Unit : N·m (kgf-m)
: Non-reusable parts
JMA00091-00071
JMA00092-00072

Advertisement

Table of Contents
loading

Table of Contents