Daihatsu 1997 Terios J100 Service Manual page 810

BO–72
INSTALLATION
1. Affix locating stoppers to the windshield glass as shown in the figure below.
2 Affix a windshield glass dam of the windshield glass to the position shown in the figure below.
3. Apply the primer for the windshield glass frame and/or windshield glass to under the adhesive agent
applying portion if the adhesive agent has been removed completely.
NOTE:
·
Do not apply the primer when adhesive materials remain on the windshield glass frame or windshield
glass. Be sure to apply the adhesive agent three minutes after the primer has been applied.
4. Apply the adhesive agent to the positions shown in the figure below.
Apply the adhesive agent in such a way that the cross section of the applied agent may measure 8 mm
in base length and 12 mm in height.
Align both ends with cut-out sections.
Dam
Adhesive agent
Glass
* The ends of the dam should be butted at
around the center of the lower section.
Unit: mm
Hook section
8
7 ± 2
35 ± 2
Unit: mm
JBO00190-00162
JBO00191-00163