Table of Contents
Advertisement
AT–78
(2) Install the clutch drum thrust washer by aligning its
protruding section with the recessed section of the oil
pump assembly.
NOTE:
•
Be sure to apply vaseline in a small amount enough to
prevent the clutch drum thrust washer from dropping.
(3) Apply a small amount of vaseline to the race side of
the thrust needle roller bearing.
NOTE:
•
Be sure to apply vaseline in a small amount enough to
prevent the thrust needle roller bearing from dropping.
(4) Install the thrust needle roller bearing to the oil pump
assembly.
NOTE:
•
Ensure that the section (A) of the thrust needle roller
bearing race faces toward the oil pump assembly side.
Reference Value:
Thrust needle roller bearing dimensions
Outer Diameter:
Inner Diameter:
Thickness:
(5) Install the following SST to the transmission case.
SST:
09351-87207-000
(6) Align the attaching holes (sections (A)) of the stator
shaft & oil pump assembly with the SST that has been
installed at the step (5).
35.7 mm
22. 7 mm
2.8 mm
JAT00222-00197
JAT00223-00198
JAT00224-00199
SST
JAT00225-00200
JAT00226-00201
Advertisement
Table of Contents
