Table of Contents
Advertisement
2. Check of starter clutch
While holding the clutch, turn the pinion clockwise. Ensure
that the pinion turns smoothly.
Turn the pinion counterclockwise. Ensure that the pinion is
locked.
If the check results are unsatisfactory, replace the starter
clutch.
Check of magnetic switch
1. Plunger check
Push in the plunger with your fingers and release your fin-
gers. Ensure that the plunger returns quickly to the original
position. If the plunger exhibits poor returning or fails to re-
turn, replace the magnetic switch.
2. Pull-in coil open circuit test
Using an ohmmeter, ensure that continuity exists between
the terminal ST and terminal C.
If no continuity exists, replace the magnetic switch.
3. Hold-in coil open circuit test
Ensure that continuity exists between the terminal ST and
the switch body.
If no continuity exists, replace the magnetic switch.
Check of bearing
Center bearing
1. Measure the outer diameter of the center bearing sliding
section of the planetary carrier shaft.
Specified Value:
15 mm
ST–13
JST00047-00043
JST00048-00044
JST00049-00045
JST00050-00046
JST00051-00047
Advertisement
Table of Contents
