Table of Contents
Advertisement
REMOVAL
1. Remove the front driver's seat. (Refer to the front seat sec-
tion.)
2. Remove the rear seat. (Refer to the rear seat section.)
(Left hand drive vehicle only.)
3. Remove the right side rear door scuff plate assembly.
(Refer to the trim & garnish section.)
4. Remove the right side deck side trim. (Refer to the trim &
garnish section.)
5. Turn over the floor carpet.
6. Remove the back door lock open lever subassembly by
removing the attaching bolt.
7. Disconnect the fuel lid lock control cable from the back
door lock open lever subassembly.
8. Remove the fuel filler opening lid lock subassembly from
the fuel inlet box by removing the attaching nut.
9. Disconnect the fuel lid lock control cable from the fuel filler
opening lid lock subassembly.
10. Remove the fuel lid control cable from the vehicle.
INSTALLATION
NOTE:
·
Basically the installation procedure is reverse to the removal procedure. Therefore, illustrations are
not given in this installation procedure. Refer to the illustrations in the removal procedure in cases
where any difficulty is encountered.
1. Route the fuel lid lock control cable in the vehicle.
2. Connect the fuel lid lock control cable to the fuel filler opening lid lock subassembly.
3. Install the fuel filler opening lid lock subassembly to the fuel inlet box with the attaching nut.
4. Connect the fuel lid lock control cable to the back door lock open lever subassembly.
5. Install the back door lock open lever subassembly with the attaching bolts.
6. Place the floor carpet on the floor. (Refer to the trim & garnish section.)
7. Install the right side deck side trim. (Refer to the trim & garnish section.)
8. Install the right side rear door scuff plate. (Refer to the trim & garnish section.)
9. Install the rear seat. (Refer to the rear seat section.)
10. Install the front driver's seat. (Refer to the front seat section.)
BO–23
JBO00055-00050
JBO00056-00051
JBO00057-00052
JBO00058-00000
Advertisement
Table of Contents
