Daihatsu 1997 Terios J100 Service Manual page 384

MT–38
2. Attach the tension spring to the input shaft bearing lock
plate.
3. Tighten the input shaft bearing lock plate with the three
bolts.
Tightening Torque:
4. Place the two pieces of the shift lock plates on the clutch
housing side.
5. Assemble the reverse idler gear, shaft and thrust washer
to the clutch housing.
NOTE:
·
When installing, install the knock pin for use in prevent-
ing rotation of the idler gear shaft to the groove section
at the clutch housing side.
·
Make sure that the gear chamfer and thrust washer
(nylon) face upward (i.e. rear side).
6. Tighten the reverse shift arm with the three bolts.
Tightening Torque:
7. Check of reverse shift arm for movement
With the idler gear pushed against the lower edge sur-
face, check that the pin moves freely (drops by its own
weight) between the position A (neutral position) to the
position B (5th gear position).
8. Assemble the tension spring.
NOTE:
·
Attach the spring to the recessed section of the arm
subassembly.
14.7 - 21.6 N·m (1.5 - 2.2 kgf-m)
14.7 - 21.6 N·m (1.5 - 2.2 kgf-m)
Idler gear Reverse shift arm subassembly
JMT00110-00093
JMT00111-00094
JMT00112-00095
A
B
JMT00113-00096
JMT00114-00097