Table of Contents
Advertisement
PRIMARY INSPECTION
Inspection of tire & wheel
1. Check that the wheel exhibits no breakage, cracks, dent,
and so forth.
2. Check the tire for wear, breakage and cracks. Also, check
that no foreign substance is embedded into the tire.
3. Inspect the air inflation pressure of the tires.
4. Inspect the runout of the tires. (Refer to the FS section.)
Inspection of wheel bearing free play
1. Jack up the vehicle and support it with safety stands.
(Refer to the GI section.)
2. Remove the rear wheels.
3. Perform the free play measurement at a point of the hub
edge with a dial gauge.
4. If the free play exceeds the allowable limit, replace the
rear axle bearing.
Allowable Limit
Axial Direction:
Vertically Against Axial Direction:
Inspection of rear axle shaft runout
1. Jack up the vehicle and support it with safety stands.
(Refer to the GI section.)
2. Remove the rear wheels.
3. Remove the brake drum. (Refer to the BR section.)
4. Perform the runout measurement at a point of the axle hub
outer edge.
5. If the runout exceeds the allowable limit, change the rear
axle shaft.
Runout Limit :
0.8 mm or less
0.2 mm
0.1 mm or less
RS–3
JRS00003-00000
JRS00004-00002
JRS00005-00003
Advertisement
Table of Contents
