Table of Contents
Advertisement
IG–6
5. Remove the cam angle sensor from the cylinder head by
removing the attaching bolt.
6. Remove the cam angle sensor cover.
7. Turn the shaft of the rotor, until the signal rotor faces to-
ward the signal generator.
8. At all four points, check to see if the air gap between the
signal generator and the signal rotor conforms to the
specified value.
Specified Air Gap:
NOTE:
•
If the air gap fails to conform to the specified value, ad-
just the air gap.
9. Adjustment of air gap.
(1) Loosen the attaching screws of the signal generator.
(2) Adjust the air gap between the signal generator and
the signal rotor to specified value.
(3) Tighten the attaching screws of the signal generator.
10. Install the cam angle sensor cover.
11. Install the cam angle sensor to the cylinder head. tighten
the attaching bolt.
Tightening Torque:
12. Check the ignition timing and adjust it, as required.
(See page IG–9)
0.2 - 0.4 mm
14.7 - 21.6 N·m
JIG00017-00503
JIG00018-00504
JIG00019-00505
JIG00020-00506
Advertisement
Table of Contents
