Daihatsu 1997 Terios J100 Service Manual page 619

BR–16
FRONT BRAKE
COMPONENTS
q
w
q Main cylinder slide pin
w Sub-cylinder slide pin
e Disc brake No. 1 pad
r Disc brake No. 2 pad
t Anti-squeal shim
y Shim
u Disc brake pad guide No. 2 plate
i Disc brake pad guide plate
o Disc brake cylinder mounting (R, L)
!0 Cylinder boot
!1 Front disc brake piston
!2 Piston seal
!3 Pin boot
INSPECTION
1. Jack up the vehicle and support the vehicle with safety
stands. (Refer to the GI section.)
2. Remove the front wheels.
3. Check the pad thickness through the inspection hole pro-
vided at the disc brake caliper as shown.
Specified Thickness:
Minimum Thickness:
If the brake pad thickness is less than the specified value
or the wear indicator emits a warning sound, replace the
brake pad with a new one.
CAUTION:
·
Be sure to replace the right and left side brake pads as
a set. Failure to observe this caution may lead to side
pull of the brake function.
4. Install the front wheels.
!3
!2
!1
!0
10 mm
1 mm
o
i
y
: Non-reusable parts
u
r
e
t
JBR00051-00043
JBR00052-00044