Daihatsu 1997 Terios J100 Service Manual page 781

INSPECTION
1. Ensure that the seat belt will not be locked until the seat
belt retractor is tilted more than 15 degrees in all direc-
tions.
Also, ensure that the locked state is retained when the re-
tractor is tilted 45 degrees or more.
2. Ensure that the seat belt will be locked when the seat belt
is pulled quickly.
3. Ensure that no scratch, wear or any other damage exists
on the seat belts.
If any damage is found, replace the seat belt with a new
one.
CAUTION:
·
Never attempt to disassemble the retractor.
·
After the anchor bolts have been tightened, make sure
that each anchor can move in a circumferential direc-
tion of the bolt.
·
Ensure that the belt in the installed state can be pulled
out smoothly and also it can be retracted smoothly in
position.
INSTALLATION
1. Install the rear seat inner belt assembly and center seat belts with the attaching bolt. Then, tighten the
attaching bolt to the specified tightening torque.
Tightening Torque:
2. Install the rear seat belt retractor with the attaching bolt and tighten it to the specified tightening torque.
Tightening Torque:
3. Install the rear seat belt upper anchor with the attaching bolt and tighten it to the specified tightening
torque.
Tightening Torque:
4. Close the seat belt anchor bolt cover of the rear seat belt upper anchor.
5. Install the deck side trim. (Refer to the trim & garnish section for the installation procedure.)
6. Install the rear door scuff plate assembly. (Refer to the trim & garnish section for the installation proce-
dure.)
7. Install the rear seat belt end anchor with the attaching bolts and tighten them to the specified tightening
torque.
Tightening Torque:
8. Install the deck board assembly. (Refer to the trim & garnish section for the installation procedure.)
9. Install the lower back trim. (Refer to the trim & garnish section for the installation procedure.)
10. Install the rear seat. (Refer to the rear seat section for the installation procedure.)
40.5 ± 12.5 N·m (4.1 ± 1.3 kgf-m)
40.5 ± 12.5 N·m (4.1 ± 1.3 kgf-m)
40.5 ± 12.5 N·m (4.1 ± 1.3 kgf-m)
40.5 ± 12.5 N·m (4.1 ± 1.3 kgf-m)
BO–43
45¡
JBO00108-00091
JBO00109-00000