Table of Contents
Advertisement
BO–58
27. Install the door trim No. 1 bracket with the attaching bolts.
28. Connect the rear door inside handle subassembly to the rear door open control link assembly.
29. Ensure that the retainers are installed on the back side of the rear door trim panel assembly properly.
30. Pass the rear door inside handle subassembly through the rear door panel while holding the rear door
trim panel assembly slightly.
31. Install the rear door trim panel assembly on the rear door panel while aligning the rear door lock control
link position.
32. Engage the retainers provided on the rear side of the front door trim panel assembly by pressing the
position where retainers are installed.
33. Hang the nail section provided on the rear door inside handle subassembly to the rear door panel and
secure the attaching screws.
NOTE:
•
An oversize screw is available.
34. Install the attaching screw of the door lock control knob holder securely.
35. Screw in the rear door locking button.
36. Close the window glass fully.
37. Install the snap ring to the rear door window regulator handle assembly in such a direction that the
open ends of the snap ring face toward the arm side of the window regulator handle assembly.
38. Attach the door vent window control handle plate in such a direction that the recessed side faces to-
ward the front door trim panel assembly side.
39. Insert the window handle assembly to the regulator in such a way that the tilt angle is 30 degrees from
the horizontal.
40. Ensure that the rear door mechanism operates properly.
41. Check and adjust the rear door alignment.
(Refer to the section under the adjustment front door and rear door alignment.)
JBO00152-00000
Advertisement
Table of Contents
