Table of Contents
Advertisement
MT–18
2. Measure the contact width section between the shift
heads and the shift inner lever.
Specified Value
REVERSE IDLER GEAR
1. Visually inspect the chamfered section of the reverse idle
gear for damage.
2. Measure the bore diameter of the reverse idle gear bush.
3. Measure the outer diameter of the reverse idle gear shaft.
Also, check its surface for scores, etc.
Specified Value
REPLACEMENT OF TYPE S OIL SEAL
1. Remove the Type S oil seal with a common screwdriver.
NOTE:
·
Do not reuse the removed Type S oil seal.
2. Install a new Type S oil seal in the clutch housing, using
the SST given below.
SST:
09606-87201-000
NOTE:
·
Prior to assembly, apply gear oil to the whole periphery
of the lip section.
SHIFT LEVER & SHIFT RELATED PARTS
REPLACEMENT
REMOVAL
1. Remove the select lever boot.
2. Remove the tight plug (if necessary).
3. Remove the Type T oil seal.
NOTE:
·
Do not reuse the removed tight plug and oil seal.
Shift heads
Shift inner lever
+0.1
12.1
+0
(d)
+0.061
20
20.0
+0.032
Unit: mm
–0.02
12
–0.12
Unit: mm
(D)
+0
–0.013
JMT00040-00031
JMT00041-00032
JMT00042-00033
SST
JMT00043-00034
JMT00044-00035
Advertisement
Table of Contents
