Daihatsu 1997 Terios J100 Service Manual page 564

4. Tightening of drive shaft end nut
(1) Install the conical washer to the drive shaft.
(2) Install the nut and tighten the nut to specified tighten-
ing torque while prevent the front axle hub from turn-
ing, using the following SST.
SST: 09511-87202-200
Tightening Torque:
CAUTION:
·
Be sure to install the conical washer in the correct di-
rection.
(3) Install the front wheel adjusting lock cap to the nut.
(4) Install a new cotter pin.
CAUTION:
·
Bend the legs of the cotter pin, as indicated in the fig-
ure.
·
When bending the cotter pin, make sure that the cotter
pin is not protruding from the head of the bolt.
5. Install the brake disc to the front axle hub.
6. Install the disc brake assembly to the steering knuckle.
Tightening Torque:
7. Install the wheel with hub nuts and tighten the hub nut fully
by hand.
8. Jack down the vehicle.
9. Tighten the hub nut to specified tightening torque.
Tightening Torque:
196.6 ± 29.4 N·m
(20.0 ± 3.0 kgf-m)
90.2 - 135.3 N·m
(9.2 - 13.8 kgf-m)
88.2 - 117.6 N·m
(9.0 - 12.0 kgf-m)
FS–11
Inside Outside
Serrated section
JFS00036-00036
JFS00037-00037
JFS00038-00038