Table of Contents
Advertisement
5. Tension adjustment of drive belt
(1) Install the following SST to the alternator and adjusting
bar as shown in the right figure.
SST:
09286-87701-000
(2) Adjust the drive belt tension to the specified value by
adjusting the nut of the SST.
Specified Belt Deflection
New Belt:
Used Belt:
NOTE:
•
As for definition of new belts and used belts, refer to
the MA section of the service manual.
(3) Tighten the alternator attaching bolts to the specified
torque.
Tightening Torque:
(4) Remove the SST from the alternator and adjusting bar.
6. Connect the alternator connector of the alternator wire to
the alternator.
NOTE:
•
Make sure that the lock of the connector is locked
properly after connection.
7. Connect the terminal B of the alternator wire to the alterna-
tor with the attaching nut.
8. Install the generator cap.
9. Reconnect the ground cable terminal to the negative ter-
minal of the battery.
10. Perform the in-vehicle inspection.
11. Install the right engine undercover.
12. Install the air conditioner drive belt.
(Refer to the air conditioner installation manual issued by
DENSO CO., LTD.)
4 - 5 mm
[with a force of 10 kgf applied to the
point shown in the figure]
5 - 6 mm
[with a force of 10 kgf applied to the
point shown in the figure]
34.3 - 54.9 N·m
(3.5 - 5.5 kgf-m)
CH–21
SST
Attaching bolt
Generator cap
JCH00073-00064
JCH00000-00066
JCH00074-00065
Advertisement
Table of Contents
