Table of Contents
Advertisement
3. Remove the screw grommet for the tapping bolts by cut-
ting off the hem section of the grommet as shown.
4. Remove the ten screw type grommets by screwing them
out.
5. Remove the front fender liner.
INSTALLATION
NOTE:
·
Basically the installation procedure is reverse to the removal procedure. Therefore, illustrations are
not given in this installation procedure. Refer to the illustrations in the removal procedure in cases
where any difficulty is encountered.
1. Install the front fender liner with the ten screw grommets.
NOTE:
·
Insert the fender liner into between the fender panel and the over fender at the three screw grommet
installing positions.
·
Install the three screw grommets for tapping bolts to the lower side of the fender liner.
2. Install the under fender bracket with the attaching grommet and tapping screw.
3. Install the front fender mudguard with the three attaching bolts.
BO–17
Cut
Screw
grommet
JBO00040-00037
JBO00041-00038
JBO00042-00000
Advertisement
Table of Contents
