Daihatsu 1997 Terios J100 Service Manual page 757

3. Remove the insulator, the hood-to-front end panel seal and
the head lamp cover-to-hood seal by removing the attach-
ing retainers.
4. Place cloths under the engine hood in order to prevent the
painted surface from being damaged.
5. Loosen the attaching bolts of the engine hood which are
connected to the hood hinges.
6. Remove the engine hood by removing the attaching bolts
while supporting the engine hood securely.
7. Removal of engine hood hinge
(1) Remove the front fender.
(Refer to the front fender section.)
(2) Remove the engine hood hinge by removing the at-
taching bolts.
Installation of the engine hood
NOTE:
·
Basically the installation procedure is reverse to the removal procedure. Therefore, illustrations are
not given in this installation procedure. Refer to the illustrations in the removal procedure in cases
where any difficulty is encountered.
1. Installation of engine hood hinge
(1) Install the engine hood hinge with the attaching bolts.
(2) Install the front fender. (Refer to the front fender section.)
2. Place a piece of cloth under the engine hood in order to prevent the painted surface from being dam-
aged.
3. Install the engine hood with the attaching bolts while supporting the engine hood securely.
4. Tighten the bolts attaching the engine hood to the hood hinges temporarily.
5. Remove the cloth.
6. Perform the adjustment of the engine hood alignment.
7. Install the insulator, the hood-to-front end panel seal and the head lamp cover-to-hood seal with the at-
taching clips.
8. Install the window washer nozzles to the engine hood.
9. Install the window washer hoses to the engine hood.
10. Connect the window washer hoses to the window washer nozzle. Tighten the attaching bolts of the en-
gine hood which are connected to the hood hinges.
BO–19
JBO00046-00042
JBO00047-00043
JBO00048-00044
JBO00049-00000