Daihatsu 1997 Terios J100 Service Manual page 587

Replacement of lateral control rod bush
1. Remove the bush, using a suitable tool in combination
with a hydraulic press.
NOTE:
•
Use a suitable tool, such as a tool indicated in the fig-
ure.
2. Apply the Samper R
bush in the lateral control rod, using a suitable tool in com-
bination with a hydraulic press.
CAUTION:
•
Be very careful not to apply pressure to the inner
sleeve of the bush. Make sure that the difference in di-
mensions at the sections A and B is within 1 mm during
the press-fitting, as indicated in the figure.
INSTALLATION
1. Install the dynamic dumper to the lateral control rod.
Tightening Torque:
2. Install the plate and bush to the lateral control rod attach-
ing stud bolt.
CAUTION:
•
Assemble the plate and bush, as indicated in the fig-
ure.
3. Install the lateral control rod to the lateral control rod at-
taching stud bolt. (Lower control arm attaching side)
4. Install the collar, bush and washer to the lateral control rod
attaching stud bolt. (Lower control arm attaching side.)
CAUTION:
•
Assemble the collar, bush and plate, as indicated in the
figure in Step 2.
5. Temporarily tighten the lateral control rod attaching nut.
(Lower control arm attaching side)
107 to a new bush. Then, press-fit the
6.9 - 15.7 N·m (0.7 - 1.6 kgf-m)
Plate
Bush
Cdor
Bush
Plate
RS–7
JRS00018-00016
JRS00019-00017
JRS00020-00018
Nut
JRS00021-00019
JRS00022-00020