Daihatsu 1997 Terios J100 Service Manual page 455

Table of Contents

Advertisement

AT–54
39. Remove the T type oil seal, using the following SST.
SST:
09308-10010-000
NOTE:
Never reuse the removed oil seal.
40. Remove the seven bolts of the stator shaft & oil pump as-
sembly.
NOTE:
Be sure to remove the bolts evenly and diagonally.
Never loosen any bolt other than the specified ones in
the right figure.
41. Remove the stator shaft & oil pump assembly with the O-
ring installed, using the following SST.
SST:
09820-00021-000
42. Remove the O-ring from the stator shaft & oil pump as-
sembly.
NOTE:
Never reuse the removed O-ring.
43. Remove the two clutch drum oil seal rings.
NOTE:
Never reuse the removed oil seal rings.
44. Remove the clutch drum thrust washer (resin made) from
the direct clutch.
NOTE:
If no thrust washer (resin made) is provided on the di-
rect clutch, make sure that the thrust washer is in-
stalled at the stator shaft & oil pump assembly side.
JAT00121-00099
JAT00122-00100
SST
JAT00123-00101
JAT00124-00102
JAT00125-00103
SST

Advertisement

Table of Contents
loading

Table of Contents