Daihatsu 1997 Terios J100 Service Manual page 677

BR–74
GRAVITY SENSOR
q Rear console box assembly
w Console panel
e Gravity sensor
NOTE:
·
The function check of the gravity sensor should be performed by the sensor check function.
The following procedure applies only to the inspection of attaching conditions, removal and installation.
1. Removal of rear console box
(1) Turn off the ignition switch.
(2) Remove the console box by removing the two attaching bolts and screw grommets. (Refer to BO
section.)
NOTE:
·
Change the shift lever position while removing the center console box in the case of automatic trans-
mission-equipped model.
2. Inspection of gravity sensor for installation condition
Check the gravity sensor for the following points.
·
Connector connecting condition.
·
Gravity sensor installing condition.
·
Ensure that the gravity sensor attaching bolts are tight-
ened properly and the gravity sensor is seated on the
floor panel properly.
Also, check that the wire harness for the gravity sensor
is not interfered with the gravity sensor.
If any trouble exists, repair or replace the gravity sen-
sor or the wire harness.
3. Removal of gravity sensor
(1) Remove the gravity sensor attaching bolts.
(2) Disconnect the two wire harness clamps from the bracket of the gravity sensor.
(3) Disconnect the connector from the gravity sensor.
4. Installation of gravity sensor
(1) Connect the connector of the wire harness to the gravity sensor.
(2) Connect the two wire harness clamps to the bracket of the gravity sensor.
e
B
6.9 - 9.8
(0.7 - 1.0)
w
B
S
: Tightening torque
Unit : N·m (kgf-m)
q
JABS00084-00040
JABS00085-00000
JABS00086-00041
JABS00087-00000