Table of Contents
Advertisement
REGISTRATION OF SUB KEYS
The vehicle is provided with one master key and two sub
keys. However, up to three sub keys can be memorized in
the immobilizer ECU by using the sub key registration
function of the master key.
CAUTION:
·
The master key (black) has the sub key registration
function. Hence, be very careful not to lose or damage
the master key.
·
If the master key is lost or damaged, it is imperative to
erase the memory of the immobilizer ECU and to re-
register the master key and sub keys, using the diag-
nosis system (DS-21).
(1) Connect the jump wire between test terminal and earth
terminal.
(2) Start the engine, using the master key.
When the engine starts, the key registration mode is
assumed.
(3) Stop the engine. Within ten seconds after the engine
stopped, start the engine with the sub key.
When the engine starts, this sub key is memorized in
the immobilizer ECU.
(4) To register the next sub key, repeat the steps (1)
through (3).
CAUTION:
·
In the key registration mode, the memories of all sub
keys are erased. It is, therefore, imperative to register
the all sub keys when a new key is added.
(5) After all sub keys have been registered, remove the
jump wire from the diagnosis connector.
(6) Ensure that the engine starts with all keys.
BE–103
JBE00360-06040
Diagnosis connector
Test terminal
Earth
(ECU-T)
terminal (E)
JBE00361-06041
JBE00362-06042
JBE00363-06043
Advertisement
Table of Contents
