Daihatsu 1997 Terios J100 Service Manual page 594

RS–14
DISASSEMBLY
1. Clamp the rear axle shaft in a vice.
2. Grind off the rear axle shaft bearing inner retainer, using a
hand grinder or the like.
WARNING:
•
Be sure to observe the operation instructions by the
hand grinder manufacturer.
•
Be sure to wear goggles during the grinding operation.
CAUTION:
•
When grinding the retainer with a grinder, if the bearing
should be ground inadvertently, most likely the bearing
may break off during the vehicle running, (because this
bearing is a critical part that sustains fully the vehicle
weight.) Also a defective bearing could result in poor
sealing. Therefore, be certain to replace the bearing
with a new one.
•
Likewise, when the bearing inner race should be
ground inadvertently, also be sure to replace it with a
new one.
3. Split the retainer with a chisel and a hammer.
WARNING:
•
Before splitting the retainer with a chisel, be sure to
wear protective goggles and gloves.
4. Pull out the rear axle shaft bearing with the rear axle shaft
bearing inner retainer.
5. Remove the rear axle shaft outer retainer from the rear
axle shaft.
6. Drive out the hub bolts from the rear axle shaft, using a
plastic hammer or the like.
CAUTION:
•
Never reuse the removed hub bolts.
Hand grinder
JRS00040-00037
JRS00041-00000
JRS00043-00040