Table of Contents
Advertisement
SR–24
Rack housing assembly
Check to see if the turn pressure tube attaching hole is not
clogged or scored.
Check that the external and inner sections exhibit no major
scores and dents.
If any damage is exists, replace the damaged part with new
one.
Cylinder end stopper
Check that the external and inner sections exhibit no major
scores and dents.
If any damage is exists, replace the damaged part with new
one.
Boot
Check the boot for rapture, deformation and major scores.
If any damage is exists, replace the damaged part with new
one.
ASSEMBLY
1. Assembly of power steering rack sub-assembly
(1) Attach a new O-ring to the ring groove of the rack sub-
assembly.
NOTE:
·
Do not expand the O-ring excessively.
·
When attaching the O-ring, apply power steering fluid
to the O-ring.
·
Care must be exercised so that the O-ring may not be
twisted during the installation. Also, be very careful not
to scratch the O-ring.
(2) Lightly rub a new seal ring No. 2 with your fingers so
as to expand the ring. Then, attach the ring to the ring
groove of the rack sub-assembly.
JSR00083-00077
JSR00084-00078
JSR00085-00079
JSR00086-00080
JSR00087-00081
Advertisement
Table of Contents
