Daihatsu 1997 Terios J100 Service Manual page 215

Table of Contents

Advertisement

EF–12
2. Check the EFI main relay.
(a) Turn the ignition switch to the "ON" position. Check to
see if the relay emits an operating sound.
(b) Remove the EFI main relay from the relay box.
Check that there is continuity between the terminals 1
and 2.
Specified Resistance:
(c) Check that there is continuity between the terminals 3
and 4 when a voltage of 12 V is applied to across the
terminals 1 and 2.
NOTE:
Even when the trouble has not been solved by repair-
ing the relay, check the wire harness.
3. Check the fuel pump relay.
(a) When the ignition switch is set to the "ON" position,
check to see if the relay emits an operating sound.
(b) Remove the fuel pump relay from the relay box.
Check that there is continuity between the terminals 1
and 2.
Specified Resistance:
(c) Check that there is continuity between the terminals 3
and 4 when a voltage of 12 V is applied to across the
terminals 1 and 2.
Check of ignition system
1. Connect a timing light to the ignition wire of the No. 1
cylinder.
2. Check to see if the ignition timing mark on the crankshaft
pully is aligned with the indicator.
Specified Value:
NOTE:
Remove the air cleaner case.
Connect the test terminal and the earth terminal with a
jump wire at the diagnosis connector.
40 - 100 Ω
40 - 100 Ω
0 ± 2° BTDC/ at Idle
r
w
e
q
Diagnosis connector
Test
terminal
JEF00033-00312
q
e
w
r
JEF00034-00313
JEF00035-00314
Earth
terminal
JEF00036-00319

Advertisement

Table of Contents
loading

Table of Contents