Table of Contents
Advertisement
(10) Install the crankshaft bearing caps. Tighten the crank-
shaft bearing cap bolts evenly in the sequence indi-
cated in the right figure.
Tightening Torque:
(11) Remove the main bearing caps with the lower bear-
ings fitted on them.
(12) Measure the plastigage width at its widest point.
Oil Clearance:
If the oil clearance fail to conform to the specified
value, measure the crankshaft main journal diameter
and select suitable connecting rod bearings or replace
the crankshaft.
(13) Remove the plastigage from the crankshaft main jour-
nals.
28. Selection of crankshaft bearings
NOTE:
•
The replacement of the crankshaft bearings should be
performed after all inspections have been finished.
•
For the selection of the crankshaft bearing as a result
of the replacement of the crankshaft, refer to the sec-
tion under "Replacement of Crankshaft."
(1) Read the cylinder block main journal diameter code
number.
NOTE:
•
The main journal diameter code comes in four kinds of
5, 6, 7 and 8.
44.1 - 53.9 N·m
0.024 - 0.042 mm
u
e
q
i
r
w
EM–77
t
o
y
! 0
JEM00321-00297
JEM00322-00298
JEM00323-00299
JEM00324-00000
No. 5 Journal diam-
eter code number
No. 4 Journal diam-
eter code number
No. 3 Journal diam-
eter code number
No. 2 Journal diam-
eter code number
No. 1 Journal diam-
eter code number
JEM00325-00300
Advertisement
Table of Contents
