Brake Pedal - Daihatsu 1997 Terios J100 Service Manual

BRAKE PEDAL

COMPONENTS
: Non-reusable parts
q Brake pedal subassembly
w Brake pedal pad
e Cushion
r Brake pedal bracket
t Brake pedal shaft
y Pedal bracket stay
u Bush
i Spring
REMOVAL
1. Remove the instrument panel. (Only when the brake pedal bracket removal is required)
(Refer to the BO section.)
2. Disconnect the connector from the stop lamp switch while unlocking its lock.
3. Remove the stop lamp switch by screwing it out.
4. Disengage the clutch cable from the clutch pedal. (Only for models with manual transmission.)
(Refer to the CL section.)
5. Remove the clip and pin from the brake pedal clevis.
6. Disconnect the wire harness clamp from the brake pedal bracket.
7. Remove the brake pedal bracket by removing the attaching bolts and nuts.
8. Remove the brake pedal by removing its attaching bolts and nuts.
7. Remove the spring from the brake pedal.
8. Remove the bushes from the brake pedal.
9. Remove the brake pedal pad and cushion from the brake pedal.
N
B
N
NOTE:
: The brake pedal shaft installed from right
side when model with left hand drive.
Contrary, the brake pedal shaft installed
from left side when model with right hand
drive.
BR–5
B
B
JBR00013-00012
JBR00014-00000