Daihatsu 1997 Terios J100 Service Manual page 848

BE–14
LOW OIL PRESSURE WARNING
Unit inspection
1. Disconnect the connector from the warning switch.
2. Connect a ohm meter. Ensure that continuity exists be-
tween the oil pressure switch terminal and the ground
while the engine is stopped, whereas no continuity exists
while the engine is running.
NOTE:
·
If not, replace the unit.
Refer to the LU section of the service manual.
BRAKE FLUID LEVEL WARNING
Unit inspection
1. Disconnect the connector.
2. Connect an ohm meter.
3. Remove the reservoir tank cap. Press down the float with a
clean rod. Ensure that continuity exists.
NOTE:
·
As for a rod to be used for pressing down the float, be
sure to thoroughly clean it. Special care must be exer-
cised to ensure that no dust nor water gets into the
reservoir.
PARKING BRAKE WARNING
Unit inspection
1. Disconnect the connector from the parking brake switch.
2. Ensure that the parking brake warning lamp or brake
warning lamp goes on when ground the terminal at the
harness side.
3. Ensure that continuity exists between the terminal and the
body earth when the parking brake lever is pulled up
ward.
REAR FOG LAMP WARNING
Refer to rear fog lamp system.
SEAT BELT WARNING
Unit inspection
1. Disconnect the connector of the seat belt buckle.
2. Ensure that the seat belt warning glows when short the
terminal at the harness side and the body earth.
3. Ensure that continuity exists between the terminals of the
buckle side.
4. Ensure that no continuity exists when insert the tongue
plate into the buckle until it clicks.
JBE00042-00318
JBE00043-00319
JBE00044-00320
JBE00045-00321
Z40 H58
JBE00046-00322