Table of Contents
Advertisement
ADJUSTMENT OF BACK DOOR ALIGNMENT
e
t
1. Gap Adjustment
(1) Loosen the attaching bolts of the hinge to the back
door.
(2) Perform the adjustment by changing the attaching po-
sition of the door panel.
If any difficulty is encountered in adjusting the attach-
ing position of the back door due to lack of adjusting
allowance, perform the adjustment by loosening the
nuts attaching the back door hinge to the vehicle shell
after the three grommets of the roof head lining are re-
moved.
NOTE:
·
Be very careful not soil or bend the roof head lining
during the loosening of the nuts attaching the hinge to
the vehicle shell.
(3) Tighten the attaching bolts of the hinge to the back
door.
q
w
r
q Specified value
Door hinge section 10.4 ± 2.0 mm
Gap:
Lateral deviation:
Not to exceed 2.0 mm
1.8 ± 2.0 mm
Difference in height:
w Specified value
2.0 ± 1.5 mm
Gap:
Lateral deviation:
Not to exceed 1.5 mm
1.5 ± 1.5 mm
Difference in height:
6.8 ± 1.5 mm
e Gap:
Lateral deviation:
Not to exceed 1.5 mm
0 ± 1.5 mm
Difference in height:
6.8 ± 1.5 mm
r Gap:
Lateral deviation:
Not to exceed 1.5 mm
0 ± 1.5 mm
Difference in height:
7.3 ± 2.0 mm
t Gap:
Lateral deviation:
Not to exceed 2.0 mm
BO–5
JBO00009-00009
JBO00010-00010
Advertisement
Table of Contents
